PDA

View Full Version : DCWIN (Draft Choice)



Thomas01
31-01-2009, 06:00 PM
I am still using this great program as I know quite a few others are also.
But lately I have met a snag.
Whenever I try to delete or move or change anything on the drawing I suddenly see a big hole appear on the upper right hand side of the drawing. This happens every time on both my desktop and a couple of laptops. I just "update" to cure it but it is a nuisance
It occasionally happened before but now it is every time.
I have done the usual - re installed the program - made sure it was set to compatibility with Win95 (in my computers running XP).
I think it must be caused by some change I have made to the computers but I am lost. Anybody any ideas?

Thomas01
11-02-2009, 10:08 PM
Well nobody came up with any ideas but quite a few people looked in.
So I had to try and figure it out for myself.
Last night I remembered I always kept my screen at 800 X 600 when using DCWIN but as I have done very little drafting work for a year or so the screen has not been set at that.
So I tried 800 X 600 again and lo and behold no problem.

Except my lousy and getting worse memory.
Tom