PDA

View Full Version : Ram Trouble



26-09-2001, 12:28 PM
Hello All
I am trying to install more ram I have 2 168 pin 64 mb sticks. On removing the 72 pins and installing the new 168 pins and restartihg my PC It will not boot up i cannot even get into set up and my monitor will not turn on I have checked the manual and it says these are compatable is there a jumper setting or something else I have to change on my motherboard to get the cmos to read them If I put the old chips back in the PC boots up fine any help would be appreciated the chip set is M571 the OEM ODis 1437 HSING=TECH ENTERPRISE CO LTD

26-09-2001, 06:04 PM
JP4 must be set to 3.3v.