PDA

View Full Version : Uniden power adaptor



Driftwood
01-09-2010, 10:00 PM
I have been landed with a AAD-92S AC scanner adaptor to fix.
Usual problem, wires beared comming out of the power pack.
Easy enough to open up & shorten up the lead but it don't go anymore.
It would have shorted out but I have repaired these before & they usually still work. No sign of any blown componants, any ideas?

Agent_24
02-09-2010, 12:08 AM
I don't fully understand what the problem is.. can you post a photo?

PaulD
02-09-2010, 12:45 AM
A new one is $35 from Uniden NZ

Agent_24
02-09-2010, 10:25 AM
Just read it again, I think I get it:

The wire was damaged and shorted out, you removed the damaged section of wire and re-soldered it inside the adapter - However, it still doesn't work... right?

I guess a fuse or a component has failed due to the faulty wire short circuit. Is it a linear or switch mode power supply? Are you getting any voltage at all or just nothing?

Please post some good photos of the insides, it makes it a lot easier to figure out...

Driftwood
02-09-2010, 10:47 AM
A new one is $35 from Uniden NZ

Ah, thanks, this may be the better option, will depend on the delivery cost.
I'll check it out.