PDA

View Full Version : Compucon Monitor Driver



05-08-2001, 10:41 PM
I have just reinstalled the software on my PC and am having display problems on my Compucon SRC1502L Monitor. I have a Winfast S280V2 video card which has the correct driver installed. My problem is that I can not get the display adjusted horizontally to fill the screen. The monitor controls for horizontal size are set to max..all other factors are OK. I have tried changing resolutions etc with no avail. Can anyone kindly advise me what could be set incorrectly?

05-08-2001, 11:30 PM
Sometimes adjusting the refresh rate can help, have a look in display/settings/advanced properties and set it to optimal if its not or try some other options listed there, otherwise you could get hold of a display utility that will allow to adjust the screen settings to a greater degree such as display doctor,
but there are probably better ones now.

07-08-2001, 02:04 PM
Hiya,

Try changing the refresh settings (Start button-> Settings-> Control Panel-> Display-> Settings tab). First try the Adapter default setting, then work you're way up. An ideal setting would be 72-75Hz.

If you think you are still having problems give us a bell at -
(09) 415-3303
or email-
stuart@compucon.co.nz

I'm sure something can be worked out.

Regards,
Stuart Todd

Technical Services
Compucon Computers NZ
Email: stuart@compucon.co.nz

The views expressed in this document do not necessarily
reflect those of Compucon Computers NZ Ltd